Mystic

I managed to get them out- deepended slot and sanded down....do you think i can re-use the frets removed or will the "grips" on the...

I did manage to get them out and the fretboard was thick enough to deepen the frets and sand down the fretboard...it is pretty thin now...

What type of wood did you use for the caul?

I managed to get them out with not much damage to the fretboard....deepened the frets and sanded....will get some flat frets and try...

thank you for the suggestion....i think I have one of those somewhere in my very old inherited and rarely used tools - will need to dig...

fretboard was pretty thin....I have the feeling I will need to plane it down very thin after removing frets (likely with a chisel) and...

i fret the fingerboard - put in the glue, then file the sides, then glue to neck and then flatten them with sandpaper and dfo the final...

can I actually yank them out once the crazy glue has gone in?

can see a little of the tang below the bead of the fret in the middle of the frets (about .5mm to 1mm)

the fretboard is still flat, but the top of the fretwire is about .5 to 1 mm higher at middle than at edges, so yes, there is a curve on...

I used a fret hammer...hammered edge, other edge then middle....in retrospect to flatten more probably should have started in the...

Hi All Making 2nd uke and was bought fretwire at local store. Discovered it was curved, not flat, but thought it would flatten when I...

HI All Trying my hand at making a classical guitar - walnut sides and back and cedar top got a bit of drift on the bandsaw when cutting...

Thank you...didn't want to have to redo!