Fitting the neck to the curve of the body

[Timbuck]

5 mins on the machine ... and the results are not too bad.

30336D06-9F4A-403D-BE09-94F3447068AB by Ken Timms,

 

[mikeyb2]

Difficult to tell from the video Ken, but am I right to think there is a dovetailed slot in that sanding block i.e. that is not a butt joint. Cheers Mike.

 

[Timbuck]

Difficult to tell from the video Ken, but am I right to think there is a dovetailed slot in that sanding block i.e. that is not a butt joint. Cheers Mike.

That's right here is close up...it's great if the neck is a bit out of line you can off set it a bit and sand off the offending side to bring it back in line , just taking a tiny bit off one side can move the nut end several mm's.
F19023B5-9B08-4A12-A22C-45039557D8EB by Ken Timms, on

 

[mikeyb2]

Many thanks Ken for going to the trouble of posting another picture, got it! Mike